Difference between revisions of "Firewall Appliance Configuration"

From Swivel Knowledgebase
Jump to: navigation, search
(No difference)

Revision as of 10:32, 9 March 2015


Overview

Each Swivel appliance has a firewall protecting access to that sever. This document details how to add and change the Firewall configurations on Swivel appliances. For information on configuring Port Address Translation, see How to run PINsafe on non-default ports, this allows ports such as 443 or 80 to be used. Forinformation on ports used by Swivel appliances see Ports.

The Swivel Administration console access can also have IP access control, see Filter IP How to Guide


Prerequisites

Swivel Appliance 2.x


Configuring the Firewall

Webmin

Configuration of the firewall is usually carried out using Webmin


Firewall Add Rule

Once logged in select Networking then Firewall. Locate the Chain RH-Firewall-1-INPUT then below this click on Add Rule.

Swivel Appliance Webmin Firewall Add Rule.JPG


Enter the following parameters:

Rule Comment description of the rule

Action to take select Accept to allow the rule

'Network Protocol select Equals and TCP or UDP as appropriate

'Destination TCP or UDP port select Equals and set the port required

Connection states select Equals and New connection (NEW)

When complete click on Save.


Swivel Appliance Webmin Firewall Add Rule chain details.JPG


Change the rule priority

Increase the rule priority so that it is above the Reject rule by clicking on the green up arrow.


Swivel Appliance Webmin Firewall change rule priority.JPG


Apply Configuration

Click on Apply Configuration to make the firewall rules active.


[Image:Swivel Appliance Webmin Firewall apply configuration.JPG]]


Testing

Known Issues

Troubleshooting