Latest revision as of 12:52, 11 May 2017

Overview

Software Only installas are managed by Swivel customers and partners, for further information see Software Install advantages and disadvantages.

This document outlines the setup of a Swivel Software only installation and the settings required that differ from a Swivel Hardware Appliance or Virtual Appliance

Prerequisites

Swivel software Versions FAQ (installed on Tomcat and Java)

OS

Ports

Swivel Management

Swivel is managed by default on port 8080 by specifying the following URL:

http://IP_address:8080/pinsafe

If a valid SSL certificate is installed then this will be an https connection:

https://IP_address:8080/pinsafe

If this port is also shared for access for other services, then it should be protected using an IP address filter and sufficiently strong authentication, see Filter IP How to Guide. Swivel recommend the use of a Hardware Appliance or Virtual Appliance with its proxy port so that the management port does not need to be made available for other services.

Swivel Single Channel Images

Only a software only install the swivel TURing and Pinpad images are served up using port 8080, (this differs from Swivel hardware and virtual appliances that use port 8443/proxy).

http://IP_address:8080/pinsafe

If a valid SSL certificate is installed then this will be an https connection:

https://IP_address:8080/pinsafe

Testing

Testing Single Channel

To test a single channel image, the following URL can be used:

http://IP_address:8080/pinsafe/SCImage?username=test

If a valid SSL certificate is installed then this will be an https connection:

https://IP_address:8080/pinsafe/SCImage?username=test

Testing Dual Channel

To test a dual channel image, the following URL can be used:

http://IP_address:8080/pinsafe/DCIndexImage?username=test

If a valid SSL certificate is installed then this will be an https connection:

https://IP_address:8080/pinsafe/DCIndexImage?username=test

Known Issues

Troubleshooting